Friday, February 25th 2011

Scythe Expands Gentle Typhoon Series with New High-RPM Fans

Scythe Co. Ltd. extends the popular Gentle Typhoon fan series by three powerful high RPM models. The new Gentle Typhoon High RPM fans are available with 3.000, 4.250 and 5.400 rpm. These high fan speeds generate an incredible airflow of 141, 197 and 255 m³ per hour (83.0 / 116.5 / 150.1 CFM).

In direct comparison to fans with similar specs, the Gentle Typhoon High RPM series scores with a significant lower noise. Like the normal GT models, a perfectly balanced Nidec Servo bearing is used, ensuring an average MTBF of 100.000 hours. The reliable motor operates with an almost fluctuation-free rotational torque. Vibrations transferred from the motor to the venturi (fan case) are reduced to a minimum.

In addition, the fan blades of the Gentle Typhoon High RPM series are equipped with a stabilizing ring. In this way, the air flow is more focused which results in a higher cooling performance. At the same time the stabilization effect further helps to reduce vibrations.

The Gentle Typhoon High RPM series is now available for €16 excluding VAT.

GentleTyphoon 120 mm High Speed Fan Series

Model Name:
D1225C12B7AP-29 (3,000 rpm)
D1225C12B9AP-30 (4,250 rpm)
D1225C12BBAP-31 (5,400 rpm)

Manufacturer: Nidec Servo Corporation (Japan)

Weight: 205 g / 7.23 oz

Dimensions: 120 x 120 x 25 mm / 4.72 x 4.72 x 0.98 in

Fan Speed:
3,000 rpm / 4,250 rpm / 5,400 rpm

Noise Level: 36.5 dBA / 44.0dBA / 50.5dBA

Airflow:
83.0 CFM = 141 m³/h
116.5 CFM = 198 m³/h
150.1 CFM = 255 m³/h

Power Consumption:
2.64 W / 6.72 W / 13.68 W

Rated Current: 0.22 A / 0.56 A / 1.14 A

Starting Current: 0.97 A / 1.35 A / 2.69 A

Input Voltage: 12 V (DC)

Operating Voltage: 10.2 to 13.8 V

Bearing: Double Ball Bearing

Connector: 4-Pin Molex Connector with additional 3-Pin Fan Speed Signal Connector

Cable Length: 30 cm / 11.81 inch

MTBF: 100.000 h / 35°C or 60.000 h / 60°C

Accessory: 4x Mounting Screw

For more information, visit the product page.
Add your own comment

31 Comments on Scythe Expands Gentle Typhoon Series with New High-RPM Fans

#1
davidm71
They totally kick but!

I didn't know that these were new fans but order one a couple weeks ago, the 3000 rpm one, and its not as noisy as other fans I've owned. I have it installed on a TRUE and you can really feel the air being pushed through the fins with your hand. Not only that my temps are pretty good on a 2600k at stock on prime95 no more than 50 degrees C where as before was hitting 70 degrees C on Intel Stock cooler. The coolest thing is that as soon as you stop priming your temps shoot back down to low idle temps immediately!
Posted on Reply
#2
pantherx12
by: Athlonite
WHAT!!!! no SilverStone Air Penetrator fans tested in either of those proffered links to multiple fan tests

and at 700rpm my SS 180mm fans put out 100cfm and make pretty much sod all noise at 1000rpm they put out 130cfm and still only a quiet murmur for noise
Seems odd to bring up your 180mm fan in a thread about 120mm fans :P

Of course there will be a difference in volume there.
Posted on Reply
#3
CBRworm
I have cooked the motherboard fan controller chips in the past with high current fans. They weren't limited to an RPM, the switching transistor let out the magic smoke then that port didn't work any more. Unfortunately it took me a few different boards before I realized that with the exception of the CPU fan header, most of them can't handle much current. These were intel branded boards and one Abit. I don't know if Asus, etc have higher current capabilities.
Posted on Reply
#4
mastrdrver
I've ran my 3000 rpm Ultra Kaza (.6 amps) off the NB fan header for a while on my old Asus P5B without a problem.
Posted on Reply
#5
Athlonite
the manual for my Asus M3A32MVP-Deluxe says it can handle 84W or 1~7A the exact words are::

The Fan connectors support cooling fans of 350mA to 2000mA (2A) (24W max) or a total of 1~7A @ +12V (84W max) spread over four Fan headers
Posted on Reply
#6
Athlonite
by: pantherx12
Seems odd to bring up your 180mm fan in a thread about 120mm fans :P

Of course there will be a difference in volume there.
Yeah I know I was just board so :slap: me :laugh:
Posted on Reply