- Joined
- Jan 23, 2011
- Messages
- 517 (0.11/day)
- Location
- St. Louis, MO
System Name | Desktop |
---|---|
Processor | Intel i7 13700K |
Motherboard | MSI Z790 Tomahawk D4 |
Cooling | Corsair XC7 Block / Corsair XG7 Block EK 360PE Radiator EK 120XE Radiator 5x EK Vadar Furious Fans |
Memory | 64GB Corsair Dominator DDR4-3200 |
Video Card(s) | MSI RTX 4090 Gaming X Trio |
Storage | 1TB WD Black SN850 / 4TB Inland Premium / 8TB WD Black HDD |
Display(s) | Alienware AW3821DW / ASUS TUF VG279QM |
Case | Lian-Li Dynamic 011 XL ROG |
Audio Device(s) | Razer Nommo Pro Speakers / Creative AE-9 w/ Beyerdynamic MMX 300 |
Power Supply | EVGA P2 1200W Platinum |
Mouse | Razer Naga Pro |
Keyboard | Deathstalker Pro |
I have finally got my LCS together. I was at work tonight when I finished assembling it. I started the internal leak test.
I hooked up my PSU to all the components but used a AC to 12V Molex to power the pump to start my test. After about 20-25 mins I went to lift my reservoir and mount it into the proper place. I heard a hiss and then a small slow leak started near the reservoir along the seal of the fitting and reservoir.
I turned off the pump and cleaned up the dripping and dried off the fitting. I tightened it down and started the pump again. After about 20-25 mins there wasn't a leak and I tightened down the reservoir in the proper place.
Before leaving work I put about a 1/2 inch stack of shop towels under where the previous leak had been.
Now, given the experience of the community, should I be okay?? I am letting it run for 24 hours but I hope it will be good for at least 12 hours until I get back into work.
I am thinking 2 things might happen:
1. All is well. No leaks, no drips, no nothing.
2. Some of the fluid is dripped out again and I burned my pump up.
Thoughts/comments??
I hooked up my PSU to all the components but used a AC to 12V Molex to power the pump to start my test. After about 20-25 mins I went to lift my reservoir and mount it into the proper place. I heard a hiss and then a small slow leak started near the reservoir along the seal of the fitting and reservoir.
I turned off the pump and cleaned up the dripping and dried off the fitting. I tightened it down and started the pump again. After about 20-25 mins there wasn't a leak and I tightened down the reservoir in the proper place.
Before leaving work I put about a 1/2 inch stack of shop towels under where the previous leak had been.
Now, given the experience of the community, should I be okay?? I am letting it run for 24 hours but I hope it will be good for at least 12 hours until I get back into work.
I am thinking 2 things might happen:
1. All is well. No leaks, no drips, no nothing.
2. Some of the fluid is dripped out again and I burned my pump up.
Thoughts/comments??