csallis
New Member
- Joined
- Apr 3, 2007
- Messages
- 102 (0.02/day)
Processor | Core 2 Duo e6300 @ 3.2 (Highest OC 3.6 Stable) |
---|---|
Motherboard | Gigabyte GA-965P-DS3 |
Cooling | Zalman CNPS9500LED + 5 Case Fans (overkill) |
Memory | 2gb Crucial Ballistix Tracer DDR2 5300 (want 2gb more) |
Video Card(s) | Connect3d X1950XT (Stock Speeds) |
Storage | 250gb Hitachi Sata 2 8mb cache |
Display(s) | Proview 17" LCD (Looking for a new one) |
Case | Jeantech Aqua |
Audio Device(s) | Creative Audigy 7.1 SE |
Power Supply | Hiper Type R 530w Modular |
Software | XP (again) will go back to Vista later in the Year |
Hi guys
I have had no problems overclocking with this hardware in the past but recently my ram died so I replaced this with 4gig of Patriot Extreme Performance PC2-6400 which works well but now since the old ram died if I raise any voltages on the FSB or the MCH on my P965-DS3 board it will not boot.
I used to run with these raised no problems and now it wont even do a mild overclock, I have ruled out that the ram is the issue as the ram isnt even been overclocked when I lower the multiplyer and set the FSB to make the ram run at its default 800mhz.
Does anyone have any ideas? im starting to think the board is on its way out.
I have had no problems overclocking with this hardware in the past but recently my ram died so I replaced this with 4gig of Patriot Extreme Performance PC2-6400 which works well but now since the old ram died if I raise any voltages on the FSB or the MCH on my P965-DS3 board it will not boot.
I used to run with these raised no problems and now it wont even do a mild overclock, I have ruled out that the ram is the issue as the ram isnt even been overclocked when I lower the multiplyer and set the FSB to make the ram run at its default 800mhz.
Does anyone have any ideas? im starting to think the board is on its way out.