Recent content by john57

try turning on the verical sync just to see if that would improve on this. When you overclock your card your FPS may run higher than your refresh rate and may cause tearing in some images.

stop using the card you could damage it with the wrong core BIOS in Memory. Send me a private message here with your E-mail address and I can send you the correct BIN update file. Then you can use DOS to flash the graphic card ROM. I will not be able to send it until tonight. Keep the ISO disk...

I did tried the ISO method on my Connect3D X800 and it made a mess but I was given a second chance and found the correct BIN file and now it is working just fine with all 16 pipes working. I got lucky on the second time I quess.

I alos have the Enermax power supply and it is normal to hear a click when powering up. take care

DanishDevil I looked at the Connect3D X800 card closely and did find the heat sink had too much play and sagging under the weight of the cooler. I solved this issue by replacing the rubber O rings under the standoffs to fiber washers to give it more stability and the heat sink maintain good...

It seems that you are missing the LM63 monitoring chip on the card. ON ATITOOL I have the temperature and fan control in addition to the things you mention. That may be part of why your card is a LE version. Go the miscellaneous and show the log file and it may show that it failed to find that...

connect3 I did had a lot of trouble in getting the Zalman cooler to stay flat on the GPU betting all copper and just two screws holding it. I not going to pull the card out again but I will show a picture on the back. ordered on 11/15

connect3D X800 I got lucky that my card from NewEgg was unlocked and I was able to unlock all 16 pipes. It had all the right F's in the right places.

just go the the ssetting scrren and on that page there is a drop down window and then you select Temperature monitoring and check mark it to measure temperature.

You need to use the Shift key when selecting the page to view the fuses

Sorry that you had many problems with your motherboard.:confused: I remember many Bios issues that I had with the Gigabyte board at one time. I just upgraded to a AND 64+ 2x processor from a Intel platform. I did had a problems with the power supplies and it took me three different power...