Recent content by leo766

xplode download your original bios off your card using GPUZ!!! and save it, then edit with RBE, after that follow instructions to a T and after that turn ur pc off, dont restart, turn it off for 1 minute, then turn it back on, after it comes on reinstall latest catalyst drivers... then check and...

that cant be right... antilles is the dual GPU 6990 codename... if thats what you have either A)download the newer version of GPUz asap, or B) you don't know that you somehow have a 6990 and are trying to unlock it?

ye too bad some sources online(google it) says the 7xxx architecture due out q4 2011 would be the shit-box models sorry to rain on your parade, if your building a system don't hold your breath, the high end versions wont be out till the quarter following the 7xxx's debut, so whenever that...

trust me save urself the trouble and use a cicuit pen instead of a wire, for jumping the BIOS pins, their on the back of the card as shown on the first post, then use the the link i posted and flash, and you should be good to go the issue is that i am not sure what exaclty the problem is, but...

hey guys if sandra says i have 1408 and gpu-z says i have 1536... which is correct? both are most current versions... also messing with the gigabyte 6950 1gb oc version, it doesn't seem to support power tune, its factory set to 1.175 and sandra says the card min/max is .9-1.175 and 140W ...

http://www.techpowerup.com/forums/showthread.php?t=151456 ^if you follow this guide after doing this bios writeprotect mod you will be fine....^ you guys reinstalled ur catalyst drivers after unlocking the bios and flashing it on the gigabyte 695OC 1gb like i did right? cuz if the OP dumped...

ok I bought a Gigabyte 695OC 1GB non-referance card on october 2nd 2011 at microcenter in va just unlocked the shaders, so much for all the BS about laser cuttings, first you must def find the bios chip on the back of the card, and take a circuit pen and connect pins 3 and 8 to over-ride the...