• Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Recent content by NeoEnigma

  1. N

    Asus Rampage MB not recognizing Sata HDD

    CPU temps are 31C at idle. Not sure if that's good or not. I managed to get Windows XP installed on my 60GB IDE drive. I cannot for the life of me get it to see my SATA. I know it works. I hooked it up to my old system to check. Maybe my motherboard is bad. I dont know, Asus isn't...
  2. N

    Asus Rampage MB not recognizing Sata HDD

    I did check in the BIOS for the hard drive and it wasnt listed in there. Someone suggested that the Hard drive and the DVD cannot both be set to master, but that is how they were configured in my last PC. I usually have a cd-rom drive set to master and all others set to slave, and a hard drive...
  3. N

    Asus Rampage MB not recognizing Sata HDD

    Hi. I just built my new system with the Asus Rampage Intel x48 motherboard. I've been having a few issues with it. First of all, the stupid processor heatsink and fan has the worst mounting screws EVER. The POS plastic pieces keep coming out so when I turn my comptuter upright, it falls out...
  4. N

    AtiTool causes black screen

    Hi! I was using AtiTool to overclock my video card. However, whenever I used it to change my memory's speed, my screen would instantly go black and wouldn't recover until a restart. So I tried an experiment: I used Overdrive in the catalyst control center to overclock my card. I managed...
  5. N

    Overclocking question (with AtiTool)

    I've narrowed the problem down to AtiTool. When I use Overdrive to set my speeds, I can get 621/1472. However, with those speeds set, AtiTool will cause my screen to go black as soon as I open it. However, this is annoying since I want AtiTool to run for its fan control. Any ideas?
  6. N

    Overclocking question (with AtiTool)

    When my system boots up, it automatically loads my profile in AtiTool. However, the very moment I click "set clock" I get black screened, therefore I can never click the save profile button, so my Ram speed is never updated in my profile. Just wondering if there was an older version of...
  7. N

    Overclocking question (with AtiTool)

    Hi! I own a Sapphire Radeon x1950 Pro 256mb. This video card is 580/1400 by default. I manually increased the clock speed to 620 (AtiTool cranked it down to 614) and I'm doing fine, idling at 43-44. However, whenever I try to increase my memory speed, my screen goes completely black and it never...
See more
Top