Recent content by Petey

A little, not to loose not to tight, just ahhhhhhhh right. Some pc instict the spirtial force or demonic mind control keeps pushing me to think, something is causing bios to hang. I've flashed it untill blue in the face, dont know, will cmd show error's of motherboard.

So fricken crazy, I did a overclock on motherboard, happened again. Have to bios reset and power on and off like hundred times with nothing connected to back of mobo. Then boom it works fine with original settings and everything intact. Seems like there is a hang in the bios some where but I've...

yea wouldn't show even bios disconnected fans and ran like a champ, could be a draw of power from a bad component. Thanks I wish they had the 78= chipset in specifications. that would help so much. x79 board so no lucid mvp Just wondering does XMP cause any abnormalities in memory read out. What...

did find there is a variation dimm issue, the memory is tested and the same D1 dimm shows abbynormal. But earlier the dimm showed bad on a diffrent slot bios change maybe? I don't know prepare for new motherboard or hope it will last a while.

Can some one post on-line where I can see it later when it happens again. That asus debug code 4f or 78 and stuck there. is because of to much current draw from high rpm or large fans connected to the headers on mobo. Its a nightmare to fight through. Could be something different down the road...

So basically I take it wont vortex, Maelstrom, water devil, Toilet Water, if holes at the bottom are separated like your alpha cool Res, figure your pumps are smaller than d5 type but your at very low restriction and travel with separated components. Looked every where and no one explains the...

I guess no one knows

Some where out there in the bios for 79xx amd cards it does show where you can select gpu 0 gpu 1 gpu2 in CMD may take a while to find but it may help to select the gpu directly for bios update or reflash.

hope they will provide the proper bios update, the motherboard shouldn't see on board gpu, or any sub system, Im sure bios update will be needed with test bench applications out there, mobo will pressure them into proper architecture. Do repairs of Gpu for people would suck to have mobo freeze...

Thought I would try vynil, its strange material, like aluminum with thick clear coat. Give it a shot. top side only, no sides or bottom. Figure good fan system pumping through provides assistance to heat building mods.

If you plan on overclocking 59xx on water cooled you may have to look into delidding your processor. To get good temps. the 4930k is a solder interface which does help, but the upgrade to a overclockable 8 core isn't there. It was like insane, 3 months after my 2011 build that cost some money...

Hello I just switch from a bay res, that I've always used to a tube res, Bitsopower 250. How do I prevent the water cyclone. I'm going to mount inlet and outlet at the bottom. I have the the water pipe on the return keep hot water at top and take cool from the bottom, in theory anyway. Will I I...

found thats better, as bare metal

what cant use a roller and pan to apply paint, just pick up a gallon too.