Recent content by romulow

Hello, i've been through some problems with my Sapphire 4870 (Click too see). I used to manage the fan speed through ATI Tray tools and in 100% it was really noisy and the speed was around 2500-3500 RPM (don't remember exactly). But, from some days now, in 100% it reaches only 900-1000 RPM. I...

Really similar results. I'm gonna leave it as it is

Temps are fine, this is the card: Cooler in 100% and temps are always below 50 C. Which is a safe voltage to do a overvolt?

The highest clock i'm getting is: 810mhz core and 950mhz on the memory. Rising the memory to like 965 already shows artifacts. I've seen people doing 1100+ on the memory and 900 on the core with stock cooler... I'm using 1.236V when overclocking. Any tips?

Question says all =) I just installed XP-64 and noticed that in ATi Tray Tools its showing 1.263V and not 1.206V as it used to show before (dunno why). Is it safe to use it 24/7?

P5Q G.Skill 2x2GB Corsair HX 620W

I'm using a Q9550@3.9 (460 * 8.5) + Powercolor 4870 1GB 784mhz core/968mhz memos

xixicoco?

Q9550 max SAFE 24/7 Vcore? It's a C1 Q9550. It is stable @ 3.8 using 1.28V, and @ 4.2Ghz using 1.32V. Is 1.32V safe to use 24/7? (temps always below 44C)

Can I unlock any pipes? Sapphire X800GT AGP DeviceID 4A4A Chip Name R420 Host Interface AGP Catalyst Version 8.4 Memory Size 256MB Memory Type DDR3 Memory Bus Width 256-bit Active Pipelines 8 Default GPU Clock 475.00 Default Mem Clock 490.00 CONFIG_DIE_FUSES 0xEFF36FFF...

Can this be modded to 16 pipelines? It's Powercolor X800GTO DeviceID 5549 Chip R423 Host Interface PCI-E Memory Size 256 Mem. Type DDR3 Mem. bus width 256 Active pipelines 12 Def. gpu clock 400 Def. mem clock 490 Config DIE Fuses 0xeff7ffff Config substrate fuses 0xffffff9f...

Well, my A8v-x doens't have BIOS options to change GPU voltages, is there any software that may do that?

Thx! So it's valid to raise the TRP to get higher mem clocks? And how about the other timing values, should I raise another? I tried 4 in TRP and got many artfacts, so I assume it's not good to lower it, and increasing it to 7 I didn't loss any noticeable fps

Another question, may I change the memory timings? Increase for better overclockin or lowering for better fps, or is it really dangerous?

Hi, just joined the forums =) I bought a Sapphire X800GT 256MB AGP, that's what ATITool tells: Device ID 4A4A Chipname R420 Host Interface AGP Catalyst Version XXX Memory Size 256MB Memory Type DDR3 Memory Bus Width 256 Bit Active Pipelines 8...