Recent content by specks

Hi guys. I've been gone for quite a while as I'm in college right now but it's great to be back. I already made a 12V regulated PSU w/ current booster and a 19W bridge type amplifier w/ an LA4440 chip. I will now be a pre-amp circuit using 2 BC109C transistors. My instructor told us to...

What is the purpose of a polarity selector on an ac/dc adapter?

With my HDT cooler, I put some in the gap between the heatpipe and the aluminum piece that holds them together and then run a very thin line down every heatpipe.

Why did they position three heatpipes to the right? I think its better to position the three to the left side since there are more fins there.

Ok i guess im a dumbass

:wtf: you an engineer or somethin?

Its kinda hard to see how this layer of air is going to transfer heat when air is better off an insulator than a conductor.

So it uses a thin layer of air to transfer heat from the stationary piece to the impeller?

Whoa clean that cooler up.

A lot of cases have already implemented this. This case is good if you have reference blower type graphics.

Netgear WPN824v2

Doesn't matter. I don't even update my drivers.

What's that?

I am right on the spot. Im okay doing my stuff at this resolution

Awesome toys there. Now can i haz your old toys?