Recent content by trebleTA

Hi i have noticed the same sort of thing, GPU-Z is reporting my card as PCI Express 2.0x16 yet under testing its running at 8x2.0 yet the card should report its pci express 3.0 it's a MSI GTX 760 and me mortheboard is a GA-X58A-UD3R with only suports up to 2.0. With no display drivers installed...

Thanks i got the OpenCL now but as u say my card is not supported with the directcompute. yet i have looked around and cant see anywere to say the HD4670 is supported or not.

I belive OpenCL is in ATI driver's since this release 10.7 link below or its just the support for the sdk. http://support.amd.com/us/kbarticles/Pages/OpenCL11ATICat107UpdateDriver.aspx or its just in that release that adds support not sure :) Is there any software for directcompute??

Thanks for getting back too me, aye the physx compat is if i got say a pci physx card. I dont get the right clock reading for memory if u look its not 800 its 796.5 MHZ you say the fan speeds are fine well 0% is wrong in my book normaly in cold mode runs at 40% yet it shows in other programs...

Hi, I noticed some problem's with Gpu-Z. Its been in the last cupple of builds. link below as u see my fan speed is 0, also the temperature's dont seem right too, the clock speed for memory is wrong. Also this card from what i belive also supports PhysX or well says its has capablity on the box...

Hi i have been useing your program for sometime now and have always found it usefull when testing but on the lastest builds i have noticed some problems with the sensors on some older cards. The card i am useing at the moment is a AGP HIS ATI HD4670 1gb mem. when i go check the sensor values...