CPU Use

[Ivan49]

Hello,

I just changed my old config (p4 2.53) for a new brand AMD 3800+ (with a NF3 ultra chipset) and I used ATItool to overclock my ati radeon 9700 pro.

With release 0.23, when I launch it (winxp sp2), cpu usage goes to 100 % all the time, so i can't use it property. I had no problem with my former config and win xp sp1.

Does anyone have a clue for me ?

 

[W1zzard]

are you sure your directx and display drivers is properly installed?

also grab latest 0.24 test build

 

[Ivan49]

Answer

DirectX9c properly installed (i suppose so)

Maybe it's an issue with new catalyst 5.5 (i installed only driver not control panel)?

 

[W1zzard]

you had both systool and atitool installed at the same time?

 

[Ivan49]

!!!

I suppose no because i don't know what is systool.

In fact, i supposed it was an issue with my 9700 pro, but I just tried with a X800 XT and i had same results (100% cpu usage).



Thanks for your help

 

[gR3iF]

i also has while scanning and showing 3d mode 100 percent but not in atitool normal

 

[Ivan49]

!!!

You're right, CPU goes 100% when 3D view is on.

But I suppose it's impossible to find max settings without 3d view ?

WinXP Sp2 issue ?

 

[W1zzard]

cpu usage should go to 100% (or 50% when using HT) while the cube is spinning, but the system should be as responsive as normal

when scanning/find max, cpu usage WILL go to 100% and WILL lag your system if you have only one cpu. this is completely normal

 

[Morlak]

Here is a pic of cpu use while ATITool 3-D View is spinning/scanning on a HT system. right at 50%.

 

[W1zzard]

well ok .. the sum of load on both cpus is around 100% with ht . 66% 33% on my system here

 

[Ivan49]

!!!

In my system (AMD 3800+,powercolor X800xt, winxp sp2), when cube is spinning, system is lagging and cube have difficulties to spin properly. When i use "find max" setting, cube is doing more "spinning jumps" (lagging more and more).

I didn't have this problems with my former config (intel 2.53,ati 9700 pro, winxp sp1) .

Ok, w1zzard you already said it's normal, but i had same problems of 100% cpu usage with catalyst 5.4 (system goes to 100% when driver is loaded). Problems can't be similar ?

 

[R350np]

I´ve this lagging too, but only if "Samurize" is running. If you have runnig Samurize too, then try to disable it for scanning.

 

[Ivan49]

Problem solved

well done !!

I've got no more lagging problem (but 100% cpu usage) when i disable epox motherboard monitoring software (so equivalent to samurize problem).

Thanks to all