EK X3 RES 250 + TJ07

[MaximusE]

Hey guys

Does anyone know if an EK X3 250 tube res would fit next to my ASUS rampage IV Extreme and tj07's motherboard tray ?

thanks

 

[MaximusE]

anyone?

 

[T-Bob]

I have one of these in my TJ07 and it was a tight fit. I had to make a custom bracket to mount it on. Though, it looks like you have a smaller aio setup. I have a 480 rad in the bottom a CPU block and two gpu blocks. So you may have more room to work with.Good luck

http://www.performance-pcs.com/ek-xres-100-d5-acetal-original-csq.html

 

[MaximusE]

the AIO is temporary. am about to make a custom loop thats why am asking if it fits. which motherboard you use? cause r4BE is wider

 

[T-Bob]

the AIO is temporary. am about to make a custom loop thats why am asking if it fits. which motherboard you use? cause r4BE is wider

I don't know if you can fit that res and an R4BE on the motherboard backplate. The R4BE isn't too much wider than a standard ATX mob, so it might fit. It will be a close fit. i would use a tape measure and check.
Btw, I'm using the Gigabyte mobo in my system specs.