[SCRATCHBUILD] Bulldozer massive case project - AMD Tribute

[CAPSLOCKSTUCK]

Dont forget the obligatory flashing orange beacon and the optional green one. You might want to add an aerial as well, often dozers are GPS guided.

 

[BaxterTheFly]

Dont forget the obligatory flashing orange beacon and the optional green one. You might want to add an aerial as well, often dozers are GPS guided.

Oh, there will be a beacon, a bacon as well XD as for antenna, perhaps if i use wireless

 

[BaxterTheFly]

Dry fitting the pipes to the current look, there will be another pipe that will go on the other side of the 24 pin that will go from GPU to res, but will go under than it will come back up, to res

I hope you like the progress so far, as i was unable to work on it for good few months due to some problems i have had :/

 

[CAPSLOCKSTUCK]

The epicness grows.

 

[BaxterTheFly]

So, i bet this is the thing you didnt expect to see
I switched to below tubing to soft tubing in order to have a little more flexibility and room for working, also i made it so that the top part is able to tip over so i can clean, manage cables, etc etc.. This is the last big change in the overall mod and it will go under water tomorrow after some details and immense cleaning, dusting, alcohol bath and all

Here are some pictures, i really hope you will enjoy them