1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Comments on Profile Post by ckoons1

  1. RCoon
    RCoon
    I sat and warmed the IHS with my hands while constantly slowing scoring around the edges of the IHS with a stanly knife blade. It took about 15 mins, and after about 10 mins I applied the blade under each corner with a fair amount of pressure to get the blade to slip under.
    Feb 13, 2014
  2. ckoons1
    ckoons1
    did you scratch up the pcb? if you did it again is this the process you would use? thx
    Feb 13, 2014
  3. RCoon
    RCoon
    i made one minor scrape on the corner of the PCB when my hand slipped but it didn't do anything. I'd do it the same way again, purely because I don't have a hammer and vice available
    Feb 13, 2014
  4. ckoons1
    ckoons1
    :)
    Feb 13, 2014