[mechtech]

Ahh the good old sonata 3, I have built 4 pc's with them. And every time I do, I send Antec my list of "needs improvement" and 3 yrs later still nothing.

-I think the door hinge should be on the other side since more often than not the PC sits on the right side of the chair, or be able to open either way.

-the leds are like lasers, they should protrude slightly to be observable from any angle, and be green for power and red for hdd

-the support bar should be notched to allow psu removal when the system is fully assembled, or have an adapter so it can be removed from the back.

-the rear fan doesnt have a 3pin mobo header anymore-so sad

-only available in black, what about [white, red, and a few others]

-case should be about 2 inches longer for clearance between big vid cards and internal fan i [if used]

- the ducting from the sonata 2 should be brought back and the user should decide to use it or not

-they finally have decent spacing between the usb ports, but i would prefer 3, and 1 esata and firewire would be nice

-the front mic and stereo jacks are not labelled in any way whatsoever

-a minor gripe, maybe an inch taller to allow for 1 inch between the bottom of the mobo[atx] and bottom of the case, for certain configs and cables, etc.

I think if Antec implemented these into the Sonata then it would truely be a great case, instead of a satifactory case.

Do it Antec, I'm waiting for a Sonata 4, listen to the people!!!