[Chicken Patty]

Originally Posted by Inioch

This is what I was thinking about now.

http://img.techpowerup.org/100611/Loop_v2.jpg

Should clean the loop a lot compared to this.

http://img.techpowerup.org/100109/IMG_0017_small.jpg



I really like that part about the 690 II. With the tempest I had to remove both cages to fit the other rad.
I was also looking at his other build photos and I think I could fit my pump on the back like he did. Mine is only 7mm wider and he has the whole support bracket there.
Like I said, I think that's going to be my next case. Only problem is fitting a larger psu and a rad on the bottom.
In the pictures he has a 16cm long psu with 29.5cm rad. That leaves 1.5cm for the cables.
A Swiftech like mine is 28.5cm so it would leave 2.5cm.

But, if I got a HX750 or HX850, they are 18cm long, so only 0.5cm for wires which is not enough.



I would do the same, have them pulling and the same on top, pulling out of the case.

I'm pretty sure you can find a good PSu that is shorter. My BFG 1000W is pretty short. You can look into that.