Quote:
Originally Posted by RejZoR
I really don't see a problem here. Ok, sure there might be problems but apparently not all nickle plated blocks are affected. They do give 24 warranty on material so if anything does go wrong it will go wrong in this time and you can use this warranty for it. If it doesn't, well you have a good block. But yeah, i do agree that Eddy should look into the issue and change the provider for this as i don't think he's doing it himself. I'm sure he's using a 3rd party contractor for this job.
|
Eddy blames The user on this matter. He has from the start.. That's the problem. He's been hiding behind language barriers and playing it off as that.. Then, making it the user that using Silver Coil/PTnuke as the ones that did something wrong.. Then after the factor that there was people that just used distilled.. It's now distilled/silver coil/PTnuke... He can't see the fact it's whats going on in the milling (production) of the block instead.. Hand picked blocks from Eddy even show that their is chips in the drill holes of the G-1/4 barb fittings.. Eddy picked that his self..
they only give 12m warranty.. It's just the factor that he finally had to up it to 24m due to the fact it has dated back since the end of 2009 that the problem started.. He's all ways done 12m and if you use Silver Coil/PTnuke, you may as well kiss the warranty good bye..
Pictures of the block
Post about it being hand picked from Eddy