Quote:
Originally Posted by vychytraly
thank you very much
sorry, my RAMs are Kingston HyperX Grey Series 2x4GB 1600MHz CL9
|
Sorry I have no experience with that specific kit.
Quote:
|
so Im going to overclock, if i understood right I shouldnt worry about uncore speed
|
If I remember right top end for uncore was like 7200-7300 mhz before it flakes out.
Quote:
but dont i hurt processor somehow if i decrease its multiplier? isnt it a too big amount of work for other multipliers? (maybe a stupid question sorry  )
|
Running a higher BCLK is tougher on the proc than running a lower multi would be.
Quote:
|
I only have 4 pin cable for electricity from PSU to processor, could it be a problem? beCause my mobo dont allow 8 pin.
|
It could but not likely until you try to push further in the OC.
Quote:
|
cant I hurt the RAMs if I overclock them to 1700 or 2400 MHz? does it have also same overclocking insurances as the processor has? (it turns off) is it a big performance difference if I overclock the RAMs too?
|
If you don't know how to test properly before booting to windows, you run the risk of corrupting data or trashing the OS entirely. Typically, yes, the PC will shut down most times before damage occurs to the ram, unless you are over volting, then its 50/50 as to what may happen.
Quote:
|
and please, Im worried about temperatures, At every site I see different numbers, how big temperature should be at the i7 870 in the burn test? and how big at HD6950?
|
At 3.5ghz i would assume during Intel Burn Test, it could be in the 70's. If you are on the stock cooler it could be much higher, since I don't know what cooler you are using its just a guesstimate. I don't get the reference to the GPU though, what about it?
Quote:
|
Thank you very much for your reply
|
That's why we are here!
