Quote:
Originally Posted by helpme
Roger that, officially confused.
I'm just running tests on 4.6 ghz now to see if its stable from raising multis. That way is simple however I've just left it all on auto. Is that the best way?
|
Well, the thing with auto settings, whilst being the simplest is not always the best, often auto will give you higher voltages than you need, for example, check your VCore under load with the auto setting, then go into Bios and set VCore a little below that, test stability then further reduce until you get to the point that the system crashes, then up it a couple of notches and you should be good, remembering that less voltage and less heat is good!
If voltages are pretty low anyway and your happy with that then just keep it how it is.