Quote:
Originally Posted by imperialreign
potentially, it doesn't look that hard to do. My only reservation, I don't know if those circuits feed any other component on the card.
If you're trying to keep them from lighting up, remove the two screws that hold the LED cover in place, and on the inside of it, you can put a small piece of electrical tape or duct tape to cover where the Fatal1ty logo shows through. It'll block the LEDs from illuminating it.
If you have the guts to take the risk, though, the two LEDs should unsolder from the PCB without much of a problem - but that's your call, you could seriously damage the card doing so . . .
|
yeah thank you, i wasnt sure if somehow the the circuits powering the LED were intertwined with other circuits that could be useful in other areas of the card. i actually wanted to switch out the LED to a different color and used "less" power" if thats even the case.