[Fitseries3]

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Setting : 9.5
FSB Strap to North Bridge : 400
FSB Frequency : 528
PCI-E Frequency: 115

DRAM Frequency: DDR2-1056mhz
DRAM Command Rate : 2N
DRAM CLK Skew on Channel A: Delay 350ps
DRAM CLK Skew on Channel B: Delay 200ps
DRAM Timing Control: Manual
CAS# Latency : 4
RAS# to CAS# Delay : 4
RAS# Precharge : 4
RAS# ActivateTime : 12
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 45
Write Recovery Time : 6
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6

3rd Information
WRITE to PRE Delay : AUTO
READ to PRE Delay : AUTO
PRE to PRE Delay : AUTO
ALL PRE to ACT Delay : AUTO
ALL PRE to REF Delay : AUTO

DRAM Static Read Control: Disabled
Ai Clock Twister : Moderate
Transaction Booster : Auto

CPU Voltage : 1.525v
CPU PLL Voltage : 1.58v
North Bridge Voltage : 1.71v
DRAM Voltage : 2.3v
FSB Termination Voltage : 1.50v
South Bridge Voltage : 1.05
SB 1.5V Voltage : 1.50v
Loadline Calibration : Enabled
CPU GTL Reference : 0.63X
North Bridge GTL Reference : 0.67X
DDR2 Controller REF Voltage : DDR2-REF
DDR2 Channel A REF Voltage : AUTO
DDR2 Channel B REF Voltage : AUTO

NOTE: IF your lucky enough to have a chip that can do this well. these settings WILL help you. it took a while to figure these out. here is the system setup...
Maximus formula with rampage 0308 bios
E8500
2x1gig's crucial ballistix tracer 1066mhz
3870x2
enermax infinity 720watt PSU