[Drizzt5]

I'm preparing to pencil mod my 4850, I just got done doing a bios flash. I can't clock any higher then I could before (I think I can clock lower) and an unusal thing happened. On load i used my DMM and it said that there was 1.3v's going through the vgpu....

All i did was flash the bios ? I don't think it's suppoused to go that high?

Did I measure it wrong? If I don't have something properly grounded will it measure higher then it's suppoused to? And I'm still on the stock cooler for the moment (my s1 is sitting right next to me, ready to go) and my temps seem good. I don't think I'm measuirng correctly. But I tried all 3 of the vgpu spots that I know of.


Anyone have any suggestions?


P.S. my card is the Asus 4850, and I flashed it using this bios.

I'm also using this DMM


And i set it to the 2 for DCV (right side of the dial) :/ If thats the wrong spot then I guess thats my problem there :P

Thanks in advance.