ATITool and Command line mode

marco · Nov 23, 2004, 08:25 AM

I noticed that resuming from hibernation or stand-by with my graphics card (X800 XT) overclocked with AtiTool leads to a failure in reinitializing the VPU.
The screen is full of garbage and the system is hung.
I stress the fact that, when not overclocking the card, this issue does not show up at all.

Since I have a little nice script I use to put the system in a suspended state, I would appreciate to have a command line mode to instruct AtiTool to load the default profile and exit.

Maybe it's already possible, but I was not able to find out how.

Thanks in advance,
Marco

Nov 23, 2004, 08:25 AM	#1
marco Join Date: Nov 2004 Posts: 3 (0.00/day) Thanks: 0 Thanked 0 Times in 0 Posts	ATITool and Command line mode I noticed that resuming from hibernation or stand-by with my graphics card (X800 XT) overclocked with AtiTool leads to a failure in reinitializing the VPU. The screen is full of garbage and the system is hung. I stress the fact that, when not overclocking the card, this issue does not show up at all. Since I have a little nice script I use to put the system in a suspended state, I would appreciate to have a command line mode to instruct AtiTool to load the default profile and exit. Maybe it's already possible, but I was not able to find out how. Thanks in advance, Marco Last edited by marco; Nov 23, 2004 at 08:18 PM.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)