1gb 2900xt atitool crash

[mandelore]

HI all, just reporting that atitool beta2 dont work on this card

I get the following crash:



previous versions just dont do anything as reported by others, no clocks etc. I really need access to voltage control coz i want to overclock and adjust the voltages

plz Wiz lemmi know if there is a solution

btw, thnx for a great tool

Mand

[mandelore]

Here is the log that was created buy atitool when it crashed in a FRESH install of vista:

2007-06-30 08:44:36 D Successfully connected to driver, version 130
2007-06-30 08:44:36 D Scanning for ATI VGA Cards...
2007-06-30 08:44:36 D Found ATI device: 0x1002 0x9400 bus 4 dev 0
2007-06-30 08:44:36 D GPU model: R600 XT
2007-06-30 08:44:36 D fbPhy: 0xC0000000, mmrPhy: 0xDFFE0000.
2007-06-30 08:44:36 D mmapped mmr to 0x340000
2007-06-30 08:44:36 D BIOS at 0x0
2007-06-30 08:44:36 D fixing bios address to 0xC0000
2007-06-30 08:44:36 D mmapped bios to 0x3F0000
2007-06-30 08:44:36 D RV6xx internal temp chip detection: failed
2007-06-30 08:44:36 D LM63 temp chip detection: success (0x1)
2007-06-30 08:44:36 D Temperature monitoring: LM63
2007-06-30 08:44:36 D HD 2900 XT Voltage controller dump:
2007-06-30 08:44:36 D VDDC: 1.000 V
2007-06-30 08:44:36 D MVDDC: 1.550 V
2007-06-30 08:44:36 D MVDDQ: 1.938 V
2007-06-30 08:44:36 D Voltage Controller: HD 2900 XT
2007-06-30 08:44:36 D Device initialized successfully
2007-06-30 08:44:36 D Scanning for NVIDIA VGA Cards...
2007-06-30 08:44:36 D Could not read driver clock table: 7

[mullered07]

try running it in compatibility mode and as an administrator?

I have a friend that has an HD 2900XT and is using the new version of ATI Tool, however she has the 512mb version but that shouldnt really make a difference...

[Schepsel]

I have exactly the same problem. Started fine in the beginning but after two days it stopped.... even the logfile is the same as yours....

[Oliver]

Hi,

Same here sapphire hd 2900xt 7.8 cats is incomptible with ati tool.........it crashes the VGA everytime. I've tried everything: drivers only, drivers and CCC, etc etc...........this piece of soft is frustrating (even though it gives better control than amd gpu tool-less guess work)

[MonsterMash]

same problem here with sapphire hd2900xt 512mb. I tried only with driver 7.9 and 7.10. Hope in some solution soon.

Bye

[Sasqui]

Same here:
Sapphire HD 2900 Pro 1GB -> Flashed to XT

Cat 7.10 with CCC running

Start ATITool... takes a minute or two for the dialog to appear and it doesn't paint completely... Non responsive so I killed the process.

Exited CCC, same result.

I'm sad