ATITool 0.0.22 released!

[diGitaL]

new version of the best ati-overclocker on earth available

fixed in this release:

• Fixes to card detection on some ATI chipsets
• Fixed "When setting the speed in the log the selected speed is shown not the actual speed it is set to." (#38)
• Added infobox about possible problems when FRAPS is running
• Removed fan control tab for 9600.
• Some fixes to "try to keep gpu temp at". It will only work while ATITool is running. If you close ATITool fan speeds are set to ATI's defaults
• Fixed temp. reading error which showed 20° on 9800s with high load sometimes
• Disabled creation of file C:\Atitool detection log.txt
• Fixed excessive log entries generated during Find Max (#29)
• Fixed 3D detection for XP SP2 + AMD64 (#25)
• Forced 3D detection on for all executables starting with "bf_vietnam" (Battlefield: Vietname) until a proper fix is found
• Forced 3D detection on for all executables starting with "nwmain" (Neverwinter Nights) until a proper fix is found
• Fixed rounding error in fan speed settings (#16)
• Fixed rounding error in font size display in temp. settings (#23)
• Added current fan speed display to fan speed settings (#22)
• Memory timings editor is active now - values are not permanent and are reset at reboot. USE AT YOUR OWN RISK.
• Gamma settings are reapplied when display mode is changed (#14)
• Gamma settings panel shows numbers (#14)
• Added fan control option "Try to keep GPU temp. at xx°C" - this option is only available if temp. monitoring is enabled
• Added mini stats to temp. monitoring settings page
• Several speed optimized artifact detection code
• Dump bios button disabled on 9200 until a fix is found
• Replace temp. remote / local by "GPU" / "GPU environment"
• Fixed cosmetic bug in temp. settings panel (#15)
• Fixed bug with log file max. size .. the value was interpreted as Bytes (#13)
• Added include list for 3D detection
• No "scan running" message to log file right after start
• Fixed crash in 3D detection for 3dmark2001 and probably other apps
• Gamma hotkeys are disabled when gamma control is disabled
• Lots of fixes based on the great feedback after the 0.0.21 release, critical fixes are already incorporated into the 0.0.21 download
• Added option to scanning settings: "disable screensaver while scanning"
• Fixed ATI fan control. for some reason ATI defaults result in fan speeds > 100% to be programmed. This means that any fan speed >75% is actually 100% (can't run the fan faster than 100%). ATITool fixes this by setting the right register on the temp. chip.
• Moved fan speed registry key so its not lost every time you reinstall ATITool

You can download the new version here!

View at TechPowerUp Main Site