1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

ATITool fan control after suspend mode

Discussion in 'ATITool' started by mikelieb, May 15, 2008.

  1. mikelieb New Member

    Joined:
    May 15, 2008
    Messages:
    1 (0.00/day)
    Thanks Received:
    0
    Hi

    I'm using ATITool 0.27b4 only for fan adjusting on a Club3d CGAX-3872DDO (3870). Everything works just fine, but if I put Windows into suspend mode for saving energy, the fan settings are lost after awakening. I must open ATITool from the tray, go to fan control and reload the fan values.

    Any way to continue with the same values after a suspend mode?

    Hope, my english is OK...

    Thanks and cheers
    Mike
     

Currently Active Users Viewing This Thread: 1 (0 members and 1 guest)

Share This Page