1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Barb Sizes...?

Discussion in 'Overclocking & Cooling' started by commandercup, Jul 10, 2008.

  1. commandercup New Member

    Joined:
    Apr 9, 2008
    Messages:
    570 (0.24/day)
    Thanks Received:
    29
    I'm really confused... I've got a MCR220 with weird barbs that don't fit my 3/8" ID tubing...

    So I have to buy some new barbs... should I be going for barbs that have 3/8" OD? since the inside of the tubing will fit around the barb's outside...

    is that right?

    also, can anyone link to me to barbs at homedepot? I've heard you can buy them there...

    I'll probably drop by microcenter to look for them as well, since I'm pretty sure I saw some there last time i went...
     
  2. rampage

    Joined:
    May 31, 2007
    Messages:
    1,050 (0.39/day)
    Thanks Received:
    69
    Location:
    Port Fairy, Victoria, Australia
    the general rule of thumb is that the outher diamater of the barb should match the internal diamater of the tubing, the exception is you can also go smaller I/D with the tubing then the O/D of the barb to get a tighter fit
     

Currently Active Users Viewing This Thread: 1 (0 members and 1 guest)

Share This Page