1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

I crank the Voltage to 1.55 in BIOS, but cpuz and HWMonitor don't see it

Discussion in 'General Hardware' started by ny_driver, Dec 18, 2009.

  1. ny_driver

    ny_driver New Member

    Joined:
    Dec 28, 2006
    Messages:
    777 (0.27/day)
    Thanks Received:
    28
    Location:
    central new york
    Any ideas why that would be. I couldn't get it to quite boot @ 250 FSB x 11 = 2750mHz until I turned the voltage up to the highest mark 1.55v.
    I know the cpu is good, I'm trying to compare this board to my AV8 I just switched from. 250-255 was as high as I could go on that board stable. Anyways back to the original question....why isn't the voltage increase recognized by the monitoring programs?EDIT CPU is only running at 31c right now too.
     

Currently Active Users Viewing This Thread: 1 (0 members and 1 guest)

Share This Page