1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Memoright Unveils HTM Series SSD

Discussion in 'News' started by btarunr, Oct 11, 2011.

  1. btarunr

    btarunr Editor & Senior Moderator Staff Member

    Joined:
    Oct 9, 2007
    Messages:
    28,430 (11.30/day)
    Thanks Received:
    13,618
    Location:
    Hyderabad, India
    Memoright, a leading provider of solid state drive (SSD) products, unveils its latest SSD solutions HTM series which delivers constant sequential performance and constant random access performance and allows MLC- based SSDs to deliver longer life span for enterprise storage.

    As Memoright’s Chairman and CEO Eric Kao stated in the keynote speech of Flash Memory Summit, “one size does not fit all in SSD world.” SSDs are not simply as a faster version of HDDs. If SSD’s performance characteristic does not match data access patterns, SSDs will not perform as expected and sometimes can be slower than HDDs.

    [​IMG]

    In some application of enterprise storage, SSD’s are required to deliver consistent performance, especially when they are working in an array or certain RAID configurations. Latency is the time with which a drive takes to respond back to host after receiving an IO command. An array of SSD’s performs the best when every SSD responds with same or similar latency. This is also the reason why enterprise HDD’s are often short-stroked to limit the movement of read/write headset thus to obtain a narrower range of latency time, while sacrificing a high percentage of capacity. In SSD world, some manufactures use high over-provisioning to ease garbage collection process in hope of limiting the latency time. It not only wastes a lot of expensive NAND capacity, but also got no guarantee. Memoright shows that it is possible to limit the latency spread without a high percentage of over-provisioning.

    Memoright HTM series SSD is tuned for enterprise storage area which demands extremely stable random access performance and lower cost storage solutions with MLC NAND. Normally MLC only takes up to 3,000 to 5,000 cycles of erasures. With Memoright’s proprietary flash writing scheme, called Endurance Write, HTM is able to boost the MLC NAND endurance up to 20,000 cycles.

    HTM uses Memoright’s proprietary controller and firmware, supports SATA II interface and is available in both 2.5 inch form factor and 1.8 inch slim design.
  2. [H]@RD5TUFF

    Joined:
    Nov 13, 2009
    Messages:
    5,615 (3.21/day)
    Thanks Received:
    1,707
    Location:
    San Diego, CA
    So this is targeted for embeded devices ect. ?
  3. Beertintedgoggles

    Beertintedgoggles

    Joined:
    Nov 15, 2005
    Messages:
    720 (0.22/day)
    Thanks Received:
    194
    What a stupid speaker:
    Lets see, SSD's have better IOPS, latency, random / seq read and write..... that just about covers it besides longevity maybe.

    Just to be clear I'm talking about the Eric Kao guy, not you btarunr
  4. Steevo

    Steevo

    Joined:
    Nov 4, 2005
    Messages:
    8,223 (2.55/day)
    Thanks Received:
    1,148
    Whodat?
    10 Million points folded for TPU

Currently Active Users Viewing This Thread: 1 (0 members and 1 guest)

Share This Page