Bios settings (All value Default) :-
In Advanced Tab -
CPU Configuration:-
C1E Support - Enable
Hardware prefetcher - Enable
Adjacet Cache Line Prefetch - Enable
Max CPUID Value Limit - Diable
CPU TM Function - Enable
Execute Disable-Bit Capability - Enable
Core-Multi Processing - Enable
Intel(R) C-STATE Tech - Enable
In O.N.E Tab -
Overclocking Navigator -Manual
Intel Speedstep tech - Disable
Ratio CMOS setting - X11.0
CPU Freqency Setting - 200
Overclock Retry Cout - 3
FSB(Bsel) to NorthBridge Latch - 1333
FSB Compesation Finetune - Disable
DRAM Frequency - Auto
Enhance Mode - Auto
DRAM Timing Config. -
DRAM RCOMP Configuration - Auto
Static tREAD Value (PL)-Auto
Cofigure DRAM timing by SPD - Enable
Extra DRAM timing setting - Auto
Clock Gen Config -
PCIE Frequency Setting - 100
CPU clock skew control - Auto
(G) MCH Clock skew control - Auto
CPU Driving control - Auto
Voltage Config -
CPU Voltage - Auto
DDR Voltage -Auto
Chipset Voltage - Auto
FSB voltage - Auto
CPU core 1,2GTL Ref Voltage - 0.63*VTT
CPU core 2 GTL Ref Voltage - 0.67*VTT
MCH GTL Ref Voltage - Auto
CPU PLL Voltage - 1.5V
cpu voltage-1.288v
NB/SB Voltage - 1.096v
DDR Voltage - 1.8172V
FSB Voltage - 1.176v
Try this out:
Overclocking Navigator -Manual
Intel Speedstep tech - Disable
Ratio CMOS setting -
x10 bring this down to 9x if you BSOD
CPU Freqency Setting -
333
Overclock Retry Cout - 3
FSB(Bsel) to NorthBridge Latch - Auto
FSB Compesation Finetune - Disable
DRAM Frequency - 667 or 1:1
Enhance Mode - Auto
CPU Voltage - 1.4v
DDR Voltage -1.9v
Chipset Voltage - 1.15v or a small touch above
FSB voltage - 1.2v
CPU core 1,2GTL Ref Voltage - 0.63*VTT
CPU core 2 GTL Ref Voltage - 0.67*VTT
MCH GTL Ref Voltage - Auto
CPU PLL Voltage - 1.5
C1E Support - Disable
Hardware prefetcher - Enable
Adjacet Cache Line Prefetch - Enable
Max CPUID Value Limit - Diable
CPU TM Function - Disable
Execute Disable-Bit Capability - Disable
Core-Multi Processing - Enable
Intel(R) C-STATE Tech - Enable
With these settings you should then be able to start working on fine tuning your fsb.
DRAM RCOMP Configuration - Auto
Static tREAD Value (PL)-Auto
Cofigure DRAM timing by SPD - Disable -Once disabled you should be able to set the following timings
5-5-5-18 tRC-25
I know they are loose right now but we are eliminating the ram out of the equation for the overclock.
Extra DRAM timing setting - Auto