- Joined
- Dec 31, 2008
- Messages
- 311 (0.06/day)
- Location
- Silicon Valley, CA
YO ITS AN UPDATE!!
(from 10-9-09)
Ok ok. Been procrastinating a lot with this project...
I've got like three updates I haven't even posted. So here i go!!
Day 1
I did some cutting on the front of the case, the pictures should basically tell the story themselves.
(had to cut some little notches to clear the screws)
(mark out the cut!)
BOOM cut... whats this for?
Oooooh... hmmmm
Hmmmmm
GASP another cut....
GASP2 what is this....
Ooooooh I see....
Interesting...
Case in one solid piece now!!
This project is beginning to lift off the ground! (wait... its just{/I] beginning? This project is almost THREE YEARS OLD!!!) xD
Yippdeedoo!
Day 2
Moar cutting!!!
Waaat!? I haven't even started yet! Oh wellz....
All fixed!
Cut cut cut!!
Looking good!
Day 3
Lets test out the hardwarez on the tech bench... sweettttt.
(No I didn't pay $350 for this... that's ridiculous!)
Little drop of MX-2
Stinky stock cooler on.
Everything fits! Alrighty...
Keep in mind, I'm watercooling everything you see here.
Day 4
So lets make some mounting holes...
(I used the casing of an old PSU to get the holes exact.)
Cutting time again!
Sweetness!
Time to mount the fan grill!
Cut out...
Filed down a bit
I think this'll work....
Good jorb homestar!!
I likes it.
Well what does everyone else think so far? (even though the best has yet to come....)
Next update comes in an hour. Hehehehe....
~Parker
(from 10-9-09)
Ok ok. Been procrastinating a lot with this project...
I've got like three updates I haven't even posted. So here i go!!
Day 1
I did some cutting on the front of the case, the pictures should basically tell the story themselves.
(had to cut some little notches to clear the screws)
(mark out the cut!)
BOOM cut... whats this for?
Oooooh... hmmmm
Hmmmmm
GASP another cut....
GASP2 what is this....
Ooooooh I see....
Interesting...
Case in one solid piece now!!
This project is beginning to lift off the ground! (wait... its just{/I] beginning? This project is almost THREE YEARS OLD!!!) xD
Yippdeedoo!
Day 2
Moar cutting!!!
Waaat!? I haven't even started yet! Oh wellz....
All fixed!
Cut cut cut!!
Looking good!
Day 3
Lets test out the hardwarez on the tech bench... sweettttt.
(No I didn't pay $350 for this... that's ridiculous!)
Little drop of MX-2
Stinky stock cooler on.
Everything fits! Alrighty...
Keep in mind, I'm watercooling everything you see here.
Day 4
So lets make some mounting holes...
(I used the casing of an old PSU to get the holes exact.)
Cutting time again!
Sweetness!
Time to mount the fan grill!
Cut out...
Filed down a bit
I think this'll work....
Good jorb homestar!!
I likes it.
Well what does everyone else think so far? (even though the best has yet to come....)
Next update comes in an hour. Hehehehe....
~Parker