de.das.dude
Pro Indian Modder
- Joined
- Jun 13, 2010
- Messages
- 8,783 (1.74/day)
- Location
- Stuck in a PC. halp.
System Name | Monke | Work Thinkpad| Old Monke |
---|---|
Processor | Ryzen 5600X | Ryzen 5500U | FX8320 |
Motherboard | ASRock B550 Extreme4 | ? | Asrock 990FX Extreme 4 |
Cooling | 240mm Rad | Not needed | hyper 212 EVO |
Memory | 2x16GB DDR4 3600 Corsair RGB | 16 GB DDR4 3600 | 16GB DDR3 1600 |
Video Card(s) | Sapphire Pulse RX6700XT 12GB | Vega 8 | Sapphire Pulse RX580 8GB |
Storage | Samsung 980 nvme (Primary) | some samsung SSD |
Display(s) | Dell 2723DS | Some 14" 1080p 98%sRGB IPS | Dell 2240L |
Case | Ant Esports Tempered case | Thinkpad | Antec |
Audio Device(s) | Logitech Z333 | Jabra corpo stuff |
Power Supply | Corsair RM750e | not needed | Corsair GS 600 |
Mouse | Logitech G400 | nipple |
Keyboard | Logitech G213 | stock kb is awesome | Logitech K230 |
VR HMD | ;_; |
Software | Windows 10 Professional x3 |
Benchmark Scores | There are no marks on my bench |
This was built from scrap metal left over from previous build.
messy wires just dont look good.
paper cardboard template.
initial concept
marking the sheet
cutting
improvised anvil.
hemming
one hemmed corner. not bad for guesstimated cuts .
all three sides hemmed. 4th side not done as there is not enough space b/w PCI bracket and PSU
Bending. started off with hammer.. then did it with muscle power.
redifining the edge to a unifrom one with hammer and the end of a file. again improvising tools.
Final fit before painting. Had to trim a bit.
painted
messy wires just dont look good.
paper cardboard template.
initial concept
marking the sheet
cutting
improvised anvil.
hemming
one hemmed corner. not bad for guesstimated cuts .
all three sides hemmed. 4th side not done as there is not enough space b/w PCI bracket and PSU
Bending. started off with hammer.. then did it with muscle power.
redifining the edge to a unifrom one with hammer and the end of a file. again improvising tools.
Final fit before painting. Had to trim a bit.
painted