Discussion in 'Reviews' started by Frederik S, Jan 19, 2008.
To read this review go to: http://www.techpowerup.com/reviews/Razer/Destructor/
Hey, anyone know what lift off distance the Razer DeathAdder has on this pad?
probely the same as anything
I was considering this so thanks for the review! It helps my decision.
The same as anything???
Well, the Steelpad 4D has 1.2 mm lift off (or 1 CD high)
Most cloth pads have 2.4 mm lift off (2 CD's high)
Some pads have 3.6 mm lift off, which is getting pretty bad.
DeathAdder also skips pixels on a lot of surfaces, like the new Steelpad S&S...yet not the old S&S.
My 'pad has a 7mm lift off!
I haven't had any problems with the DeathAdder skipping on the S&S at all. Sure you have updated its firmware PimpUigi? I will test the exact lift-off distance on the Destructor later today. Lift-off distance was not a problem for me so I guess it is about 2 mm without knowing it precisely. Stay tuned for a small update.
3 mm from the hard plastic bottom of the mouse to the pad. With normal feet on that equals about 2.5 mm lift-off distance. With normal after market thick teflon feet about 2 mm. So a normal lift-off distance nothing horrible.
Separate names with a comma.