Tri-X Fury low VDDC

[Spec-Chum]

My default VDDC seems kinda low at 1.1625v or 1.1688v @ 100% load (reported by GPU-Z).

Not sure if this is a good thing or not. I thought the default was 1.2v?

Can someone else run Heaven and post the VDDC for a non X Fury?

Oddly it goes up to 1.1938v at 0% load when the clk is slightly lower.

Eh?

 

[Jetster]

Check the thread for heaven. But I wouldn't worry about it

 

[Jack1n]

I believe this is due to to vdroop, as the current goes higher the voltage is forced to drop, this is quite common.

 

[Spec-Chum]

Ah, I didn't even give vdroop a thought, makes sense.

Seems I have a decent chip if it's stable at 1050MHz at those voltages, especially since all it's CU's were successfully fully unlocked, so it's now an air cooled Fury X.

Thanks!