1. Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Typhoon III

Discussion in 'Overclocking & Cooling' started by mrsemi, Oct 8, 2009.

  1. mrsemi

    Joined:
    May 22, 2007
    Messages:
    658 (0.24/day)
    Thanks Received:
    67
    I got my reservoir last night still waiting on the cpu cooler.

    http://i202.photobucket.com/albums/aa285/TemperVale/TyphoonIII.jpg

    I've still never water cooled anything, I'm looking at this like a mystical jewel. Not sure how to fill it and am a little nervous about the one little seal in the pump area. Doesn't seem like enough. Any advice on this thing?
     
  2. kenkickr

    kenkickr

    Joined:
    Dec 5, 2007
    Messages:
    4,827 (1.92/day)
    Thanks Received:
    1,452
    Check out my Typhoon III here. All you have to do to fill it is once everything is hooked up and exactly how you want it tip the case so the back is on the floor and remove both fill ports on the res. Fill her up and jump your PSU(Make sure your PSU is ONLY powering the pump cause your bleeding the loop(s)). Keep adding water to top it off and let her bleed out(remove the air from the system).
     
    mrsemi says thanks.
    Crunching for Team TPU
  3. mrsemi

    Joined:
    May 22, 2007
    Messages:
    658 (0.24/day)
    Thanks Received:
    67
    Oh, I didn't even realize that was meant for a front bay, so the metal bolts are where you fill... I'll be sure to read the whole post, thanks.
     

Currently Active Users Viewing This Thread: 1 (0 members and 1 guest)

Share This Page