Ok... I've got a P4 2.8 Prescott / 512DDR with a HIS Excalibur x800 pro VIVO (256AGP) card...
I've pencil modded the card to 1.471V and changed the original IceQ II HSF to a custom thingie with an Akasa HFS...
I did change the bios to an HIS XT PE with 16pipelines but I got EXTREMELY MANY artifacts in low cores...
I also tried HIS XT pro and a couple more with no luck either...
Using ATItool I got it up to 621/500 with no artifacts at around 32 degrees when not in use...
The thing is that with ALL tests enabled in 3DMark05 (6 of 6), 1024x768 and 6 antialiasing I'me getting a 4500 score!
Is this too low or what the ****???
Any ideas On these would be more than welcome!
1. what I should change on ATI options or anywhere else (I'm using DNA ATI)?
2. what is a good score for this system? - and what tests and on what resolutions etc I should run 3DMark05...
3. Any other mods I can use with Air cooling?
Thanks in advance! :>
Ps. This is my system 3DMark05 - System Info
I've pencil modded the card to 1.471V and changed the original IceQ II HSF to a custom thingie with an Akasa HFS...
I did change the bios to an HIS XT PE with 16pipelines but I got EXTREMELY MANY artifacts in low cores...
I also tried HIS XT pro and a couple more with no luck either...
Using ATItool I got it up to 621/500 with no artifacts at around 32 degrees when not in use...
The thing is that with ALL tests enabled in 3DMark05 (6 of 6), 1024x768 and 6 antialiasing I'me getting a 4500 score!
Is this too low or what the ****???
Any ideas On these would be more than welcome!
1. what I should change on ATI options or anywhere else (I'm using DNA ATI)?
2. what is a good score for this system? - and what tests and on what resolutions etc I should run 3DMark05...
3. Any other mods I can use with Air cooling?
Thanks in advance! :>
Ps. This is my system 3DMark05 - System Info