After i completed the worklog on the single loop.. I didn't like the temps i was getting so i gutted the case again and began modding the case to accept a 240 rad on the bottom panel. LazyMan @ West Coast Mods inspired me on this mod due to his SkullCrusher build. I cut out all 3 mesh grills on the top panel for better airflow of the 6 push/pull 120's on the top 360rad, and mounted a koolance 360 fan shroud with the skull grills from MNPCTech.com. I cut out the bottom hard drive cage, cable management cover and rails to make room for the 240rad, the 120rad is now out. I cut the faceplate of the rad out of the bottom panel and added window edge molding and a 240 magnetic mesh dust filter. I had to add a support bracket to help lift the mid-plate under the hot-swap bays (it was starting to droop), so i used some metal from the bottom panel. I also added a push/pull config to cool the hot swap bays. I cut out 2 120mm holes on each side panel, with the windowed panel as the "push", with dust filter and skull grill (a 140 aerocool shark is drawing air in), and a LianLi fan drawing air out on the other side...it too has a skull grill. I also added a NZXT touch screen fan controller and I modded a 5.25 bay cover to accept 3 led rocker switches that are wired up to the 3 Uv cold cathode lamps. oh, and the 24 pin power to the mobo is sleeved.