Report an Error

ATI 3D Rage PRO PCI

ATI 3D Rage PRO PCI Image ATI 3D Rage Pro Image
The 3D Rage PRO PCI was a graphics card by ATI, launched in March 1997. Built on the 350 nm process, and based on the 3D Rage Pro graphics processor, in its PCI variant, the card supports DirectX 6.0. The 3D Rage Pro graphics processor is a relatively small chip with a die area of only 80 mm² and 8 million transistors. It features 1 pixel shaders and 0 vertex shaders, 1 texture mapping units and 1 ROPs. Due to the lack of unified shaders you will not be able to run recent games at all (which require unified shader/DX10+ support). ATI has placed 8 MB SDR memory on the card, which are connected using a 64-bit memory interface. The GPU is operating at a frequency of 75 MHz, memory is running at 75 MHz.
Being a single-slot card, its power draw is not exactly known. Display outputs include: 1x VGA. 3D Rage PRO PCI is connected to the rest of the system using a PCI interface.

Graphics Processor

GPU Name: 3D Rage Pro
GPU Variant: PCI
Process Size: 350 nm
Transistors: 8 million
Die Size: 80 mm²

Graphics Card

Released: Mar 1st, 1997
Production Status: End-of-life
Bus Interface: PCI

Clock Speeds

GPU Clock: 75 MHz
Memory Clock: 75 MHz
75 MHz effective

Memory

Memory Size: 8 MB
Memory Type: SDR
Memory Bus: 64 bit
Bandwidth: 0.600 GB/s

Render Config

Pixel Shaders: 1
Vertex Shaders: 0
TMUs: 1
ROPs: 1
Pixel Rate: 0.0750 GPixel/s
Texture Rate: 0.0750 GTexel/s

Board Design

Slot Width: Single-slot
TDP: unknown
Outputs: 1x VGA

Graphics Features

DirectX: 6.0
OpenGL: 1.1
OpenCL: None
Pixel Shader: N/A
Vertex Shader: N/A

VGA BIOS

Find graphics card BIOS for this card.

GPU-Z Validation

Find GPU-Z validations for this card.