ASUS GTX 580 Matrix Platinum 1.5 GB

ASUS GTX 580 Matrix Platinum 1.5 GB

Value & Conclusion »

Overclocking

The overclocks listed in this section were achieved with the default fan and voltage settings as defined in the VGA BIOS. Please note that every single sample overclocks differently, that's why our results here can only serve as a guideline for what you can expect from your card.



Maximum stable clocks of our card are 883 MHz core (8% overclock) and 1125 MHz Memory (12% overclock).

GPU overclocking potential is in the typical range for a GeForce GTX 580 card. Memory dissapoints though with just 1125 MHz, probably an unlucky sample as usually the Samsung memory OCs much better.

Overclocked Performance

Using these clock frequencies we ran a quick test of Call of Duty 4 to evaluate the gains from overclocking.


Actual 3D performance gained from overclocking is 8.2%.

Temperatures


Temperatures are comfortably low in all tests thanks to the triple slot cooler design.

Voltage Tuning

It has been a long known fact that overclocking headroom increases as soon as you increase the operating voltage. Until recently, software voltage control on VGA cards has been the exception and most users were not willing to risk their warranty by performing a soldering voltmod. Nowadays almost all current graphics cards have voltage control in order to achieve low power consumption by lowering voltage when in idle or slightly loaded.
In this section we will increase the GPU operating voltage step by step and record the maximum clock speed possible. Voltage is listed as the value that the voltage regulator reports via software, not actual measured voltage. The card was installed in-case, with fan settings at default, memory will not be overclocked either. If a card has thermal throttling we will reduce the operating frequency to keep performance as high as possible for a given voltage. Please note that the fan profile will have an effect on observed temperatures: if the card gets hotter the fan will ramp up to reduce temperatures or keep them from rising fast.

The following graph shows the overclocking potential we saw on our sample. GPU clock is represented by the blue line, which uses the vertical clock scale on the left. The scale starts at the default clock to give a feel for the overclocking potential over the base clock. Temperature is plotted in red using the °C scale on the right side of the graph. An additional graph shows full system power draw in orange, measured at the wall socket when running at the given voltage, clock & temperature.



Once you start pumping some extra juice through the card, the maximum clock frequency increases almost linearly. With software, you can only reach a maximum voltage of 1.15 V, but thanks to the hardware buttons you can apply an extra boost, up to 1.275 volts, which seems a reasonable maximum considering the temperatures. With better cooling I see this card easily passing 1000 MHz.

Clock Profiles

Modern graphics cards have several clock profiles that are selected to balance power draw and performance requirements.
The following table lists the clock settings for important performance scenarios and the GPU voltage that we measured. We measure on the pins of a coil or capacitor near the GPU voltage regulator.

Core
Clock
Memory
Clock
GPU Voltage
(measured)
Desktop51 MHz68 MHz0.95 V
Multi-Monitor810 MHz1002 MHz1.08 V
Blu-ray Playback405 MHz162 MHz0.96 V
3D Load816 MHz1002 MHz1.09 V
Page:
Next Page »Value & Conclusion