Sunbeam Tuniq Tower

Installation Continued

Next the fan connector was plugged into the motherboard. Since the wires are so long they had to be bundled up and tucked out of the way, which makes it look somewhat messy.


The next step was to install the PCI plate fan controller. The knob needed to be removed since it was too large to fit inside the space. Align the controller and secure it in place, then plug the connector from the fan into the header on the controller. Again, the wires here are a bit long, too, and they needed to be bundled up tucked out of the way. Replace the knob making sure to align it with the label on the PCI plate.


With the assembly complete the size of the Tuniq Tower becomes a concern. Installed it is nearly as tall as the motherboard tray, but it managed to slide into the case with little room to spare. Once everything is installed back into the case there was plenty of room around the heatsink.