Super Flower Golden King 1000 W

Super Flower Golden King 1000 W

Packaging, Contents & Exterior »

Specifications

Super Flower SF-1000P14PE Features & Specs
Max. DC Output1000W
PFCActive PFC
Efficiency80 PLUS Platinum
Operating temperature0°C - 50°C
ProtectionsOver Voltage Protection
Over Power Protection
Short Circuit Protection
Cooling140 mm Double Ball Bearing Fan
Dimensions150 mm (W) x 86 mm (H) x 180 mm (D)
Weight2.6 kg
ComplianceATX12V v2.2, EPS 2.92
Warranty5 years
Price at time of review (exc. VAT)$183


Strangely enough only the basic protections are present in this PSU, at least according to Super Flower. Thankfully the fan uses ball bearings so it will have a longer lifespan, compared to a sleeved bearings one. The unit's dimensions are normal for the 1000W capacity but its weight is above average, indicating that large heatsinks are used in its internals to assist the fanless operation mode at lower loads. From the "Compliance" row you will notice that the PSU meets the older ATX spec, v2.2 and not the newer 2.31. The reason behind this is that 2.31 requires at least two +12V rails while this unit has only one.
Finally the warranty period is long enough at five years and the most important of all, its price is very good for a 1000W Platinum unit.

Super Flower SF-1000P14PE Power Specs
Rail3.3V5V12V5VSB-12V
Max. Power20A20A83A2.5A0.5A
100W996W12.5W6W
Total Max. Power1000W


Let's start this time from the minor rails. These look kind of weak but for a modern system 100W from the minors is more than sufficienct. What really counts is the power that the +12V rail can deliver and in this case it can output almost the full power of the unit, even at 50°C. The 5VSB rail ideally should deliver 1A more power (3.5A in total) and not mere 2.5A, which is usually the power that 400-600W PSUs deliver at this rail.

Cables & Connectors, Power Distribution

Native Cables
ATX connector (550mm)20+4 pin
8 pin EPS12V (610mm)1
4+4 pin EPS12V/ATX12V (610mm)1
6+2 pin PCIe (560mm)2
Modular Cables
6+2 pin PCIe (500mm)2
6+2 pin PCIe (500mm+130mm)2
SATA (500mm+130mm+130mm+130mm)12
4 pin Molex (500mm+130mm+130mm)3
4 pin Molex (500mm+130mm+130mm) / FDD (+130mm)3 / 1


The number of connectors is satisfactory with the six PCIe and the two EPS being available at the same time. Regarding their length we would like additional 50mm at the 24pin cable and all PCIe cables to have at least 600mm distance up to the first connector. Also the distance among the connectors ideally should be 20mm more, to match the ATX spec recommendation. Finally all native cables are sleeved all the way back into the casing and use thicker AWG16 wires, while the modular ones consist of flat ribbon wires with AWG18 size.

Since this PSU features a single +12V rail we do not have anything to comment about its power distribution.
Page:
Next Page »Packaging, Contents & Exterior