Recent content by Anzlew

Single ADATA m.2 drive.

Thanks for hint, but the fan is installed properly. I don't have any issues with temperature. The only thing that bothers me is the noise of this 140 Akasa fan running on full speed. But i think it is the price of performance. Everything with my airflow is fine. I have a slight overpressure but...

Hi. My case is equipped with 5 fans: IN - 3x120mm Noctua NF-S12; OUT: 140mm Akasa Viper + CoolerMaster SickleFlow 120 Blue LED. All are controlled by NZXT Sentry 3 with thermal sensor installed under VRM heatsink. On quiet and power mode it runs very quiet. On 100% only the 140mm is noise is...

I have forget to turn on the Ryzen Balanced power mode :shadedshu:. After turning it on the power consumption doesn't look bad at all. The Vcore voltage goes very high pretty often, but generally it started to drop. Max values are from Cinebench runs.

It seems like. During Cinebench tests it drops down to 1,331V. It's opposite to all I know about it and it feels strange :twitch:

Same here. I don't know from where CPU-Z has taken the value which is in my validation :(

Hey. I've read it too. Thanks for reminding me where it was. This article was the reason why I wasn't afraid about the CPU. When I will be back at home I will recheck it again. Thanks for the clue.

I have cleaned my startup before updating the CPU. Despite no load the CPU doesn't want to lower the frequency. Maybe it is problem with readings of the software? I am using H/W monitor to check the parameters. Question is if it is not connected with the fact that I have B350 mobo. But...

In idle my CPU is around 1,45V and the frequency is around 4,3GHz. When under load it goes down to 1,33-1,35v - 4,1GHz. I've tried to set the Vcore voltage manually to 1,35V but afterwards my results in tests was much lower. What is strange are the CPU and VRM's temperatures. Despite the 1,45V...

My current rig.

Just yesterday i've installed a Ryzen 7 3700x on my MSI b350 Tomahawk Arctic and after couple of tests and 3 hours od playing everything looks fine. Today i have rendered an image in 3ds Max and the CPU and Vrm temps was max 56 and 51 deg C . The whole process took around 12min. I am very happy...

My results, with slightly OC'ed GPU: