Recent content by forumsviewer

indeed am running 64 bit version. thanks for the heads up.

hrrmm, well i've been using inplace large ffts and getting the issue to arise within 4 hours. It ran for 6 hours with the increased CPU voltage and no BSOD. I'm trying to keep variables the same and only change one (such as voltage)

Have been using in-place large.

The specs on the memory say 1.65v for the memory. I haven't adjustd voltage for QPI or memory in the BIOS (i kept them at auto). Prime95 has ran for the past 6 hours. It would normally BSOD by now. I will stop Prime95 and start testing with OCCT LinPack 1hr test to see if I can get it to...

I havent touched anything in the BIOS concerning QPI.

if not mistaken, the memory is setup at the stock part number values.

At first I was getting BSOD of PAGE_FAULT_IN_NONPAGED_AREA (50). It would happen within 4 hours of Prime95 running. I then tested each memory module and found one of the six to not post the system if in by itself. So I replaced all of the memory. Started running Prime95 again and within 4...

memory is patriot PGS312G1600ELK (using 24GB in 4GB modules). Specs are PC3-12800 (1600MHz) 9-9-9-24 @ 1.65v. CPUZ says it is running at 9-9-9-24 2T 800mhz 2:12. Remember, this memory I replaced all the modules because my mini dump from before running prime95 said PAGE_FAULT_IN_NONPAGED_AREA...

It has been running Prime 95 for a bit over 2 hours now and 980X temperature highest is 64* C (147* F). It usually does its restart within 2 to 4 hours of Prime95. Below is a minidump from BEFORE setting voltages manually within BIOS where it restarted. (AUTO showed voltage as 1.168 at idle)...

I have an Asrock X58 Deluxe motherboard with an Intel six core 980x processor with 24gb Patriot PC3-12800 1600mhz memory. I am looking for stability, not overclocking. With the BIOS settings all on AUTO the CPUz says core was 1.168, core @ 3.466, multiplyer 26, bus speed 133.3 and QPI 3200...

Any other comments?

any ideas?

FURTHER UPDATE: If you recall, plugging directly into the modem fixed the problem. Last night plugged into the router and the router into the modem and it dropped. Problem is back. Now we've tried 3 different routers and other systems on the same network don't have the issue. Would this lead...

bump for night crew

UPDATE tried a different version of java and also plugged directly into the modem and all night long the program DID NOT drop. This means I changed two variables. Variable 1 ) Changed java version. It is possible the java version I was running didn't work very well Variable 2 ) Plugged directly...