• Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Recent content by GerKNG

  1. GerKNG

    Days Gone on PC

    i played it on a PS4 Pro and the game is the most average Sony like experience you can imagine.
  2. GerKNG

    Problem with RX6800 Bios Flash

    i'd never use DDU without it. do the following. download the latest driver go into the device manager, disable your LAN/Wifi (whatever you use to connect to the internet) boot into safe mode, run DDU, reboot, install the driver and then re enable your LAN/Wifi in the device manager. Reboot again.
  3. GerKNG

    Problem with RX6800 Bios Flash

    deleting the SPPT must fix it because it is the ONLY thing that influences it (it just gets scanned when booting) are you 100% sure that you did not flashed any bios on your card?
  4. GerKNG

    Problem with RX6800 Bios Flash

    well then open MPT, load the bios again, pick your GPU in the top drop down menu and go into the settings and click on delete SPPT, then reboot.
  5. GerKNG

    i tested the influence of cache overclocking for Gaming. (Cache beats Core) R6 Siege.

    a Quick Benchmark in Rainbow Six Siege. Tested at 720p with the lowest Settings. Hardware: 10900K(F) 6900XT Nitro+ 32GB 3600Mhz CL16 Z490 Prime A every test was repeated three times and the results are the Average value of each run. explanation for values (49/43 = 4.9 Ghz Core /4.3 Ghz Cache)...
  6. GerKNG

    Problem with RX6800 Bios Flash

    i am sorry but i only own 6900XTs do you deleted the SPPT? because since you didn't flashed the bios the card is not "messed up" only the registry file of the SPPT.
  7. GerKNG

    Problem with RX6800 Bios Flash

    well the thread is called problem with rx6800 bios flash. i guess you have the voltage so low that it is below the actual minimum voltage of the GPU. (btw. what's the point of running a GPU at .6V? emulating a 1050 ti?) and the stuck values are a known issue ( i had to reinstall the drivers...
  8. GerKNG

    Problem with RX6800 Bios Flash

    why do you flash a bios when we have tools like MPT?
  9. GerKNG

    Arctic MX-5 is here boys!!!!! Tests incoming!!!

    MX5 is pretty much identical to NT-H2 since i replaced it with the MX5 Just use a little bit more paste than usual because the paste spreads very little compared to others.
  10. GerKNG

    Bit concerned about temps.

    you run the heaviest stresstest you can find, have quite decent temps and you get concerned about the temperatures :D imo you overthink the whole situation. your temps are completely normal and in P95 actually pretty decent. no worries, everything is fine. just... don't buy a 5800X :roll:
  11. GerKNG

    How is this PSU still a best seller after everything ?

    well.. as bad as it is. person xyz buys the PSU, it works fine and does it's job. write a positive review.
  12. GerKNG

    Bit concerned about temps.

    why do you run Prime95 in the first place?
  13. GerKNG

    I7 10700k air cooling options??

    19°C Ambient, NH U12S Chromax. Fan at 90% fixed. still running over 70-75°C constantly and spikes into the mid 80s (while playing warzone...) and Summer is another thing. that was at 5.1 Ghz 1.29V VRVOUT (150A) once the cooler is warm (like two Cinebench Runs or 20-30 minutes of playing CPU...
  14. GerKNG

    I7 10700k air cooling options??

    i acutally used an NH U12S on a 10700k a while ago. it's "enough" for stock/stock clocks with manual tweaked voltage but overclocking is an absolute no go. the NH D15S, NH D15 or other beefier coolers are totally fine but the tiny 120mm heatsink heats up way too fast.
Top