Recent content by ivan__jedi

According to some online material i have come accross. This problem is very likely due to the motherboard design of ASUS. Its x38 motherboards seem have fairly poor overclocking capability if all four dimm sockets are used. In contrast, Gigabyte x38 series dont have this porblem. I think...

thank for ur tips fitseries3 however it didnt work very well i still need some 1.9 volt (@ 9-9-9-26)to just get into the system and then die i start to seriously wonder if it is the problem with the motherboard??

the sticks are definitely fine. i tried them seperatly ran memtests they worked ok i also, as binge suggested, messed with the ratio and overclocked the system didn't work at all so far no progress sigh

thanks for the advices i am a noob totally tried dimm 1.90v 8-8-8-24 didn't work 1.96 allowed me into the system but died when i tried to run cpuz could u guys give me some advices on the cas config??? 9-9-9-something??? nb @ 1.49v i dont understand since its default...

recently i upgraded my supertalent ddr3 pc3-12800 memory from 2g to 4g. then the system could not start up at all unless dimm voltage at 2 volt @ 1600mhz !!!! must know that the supertalent ddr3 pc3-12800's default voltage is 1.8v and it was running perfectly at default profile when there...

does anyone know can i build a raid 0 system using a sata drive and a sata 2 drive?? or the two hard drives must be exactly the same? thanks

what about 975 ??

Does anyone know if intel's i955x chipset supports new 65nm cpus such as Conroe? I have heard that some manufacturers succeed to make their 955x based motherboard support 955xe cpu?