Recent content by jonkb

It was the CPU. I controlled every movement. And I dont think I lapped to much, as the silver corners didn't go away until I was done.

As I said. In MY book.:) It made things worse for me.

Yep, that was just what I did :) Ah okay :) The only thing I had to do with my previous motherboards was to install the internet driver, nothing more. Thanks alot for your input. I'll try that!

2 hours!? Takes me 40 min with a WD Raptor :) Ok. updates: i tried all your suggestions. Disable the connection in device manager, and then take the PCI card out and in again, reboot, activate again = same results. installed SP3 = same results... tried to repair, but it fails... 7...

Nope, not yet, but I will. And I will be back with news...

We are connecting to the SAME place. We cannot both be on. But thanks :)

I'm doing that for the third time now at the time:rolleyes:

I'm connection to the same place with my moms pc, as with my pc.

SP2 now. Maybe I should install SP3? No changes besides that, that i know of-

It does detect, and there is green light and all, but it just keeps searching and searching and nothing happens.

I'm using XP Home Editon 32 bit. I've never made any modifications in Windows...

It's got to be a software problem, because my mothers connection is fine.

I'm just changing the cables.....;)

It's a good board, yes, but it's buggy:( What router? I'm connecting directly. yeah, the drivers installed without problems. do you think maybe it's because my bios is modded?

I bought a lapping kit with glass. There were 400, 800, 1000, 1200, and 1500 grit. I controlled every movement, and it took me damn 6 hours to get the silver corners away. After that i took 800 and 1000, and then made it finish. My load temp got 6-7 C worse, and 3-4 degress worse in idle. So I'm...