Recent content by proooo

oh I forgot the question because of how excited I was sorry :D, despite having quite exaggerated power limits, ryzen controller does not apply settings,I can't find a reason but disable stapm boost in bios and use renoir mobile tuning for better results. I have a question here, I would like to...

I investigated a lot and finally managed to raise the power limit, I am somewhat satisfied since I could not configure the frequency of fclk, it stayed at 800mhz. fuck lenovo. Playing temperatures are around 80c-90c, with stock thermal paste personally I use a limit lower than 54w since it is...

interesting, with time I will improve it, later I will upload photos of the final result

The problem with these switches is that they are not two-way, the switch that I put is two-way because it alternates two cables since this laptop has two fans and I need to alternate two pwm signals

sorry, I have not taken photos I was doing tests, later I will take more photos as I will correct the wiring. Exactly !, that is possible by leaving the yellow cable connected, which would be the fan detection, if you disconnect that cable, the bios activates the protection systems and turns...

the switch alternates the blue and green wire of the fans, what would be the rpm control, the fan has 4 wires, you have to leave the yellow wire that would be detecting the fan or otherwise the equipment is protected, I will draw a diagram. to you make this modification, the motherboard would...

I did a modification to put the fans to the maximum manually (more than with the performance mode that includes). With this mod I got a reduction of 10c playing demanding cpu games like Fortnite, I went from 93c to 78c-86c. I added a switch to be able to choose if I want the fans to the maximum...

Yes, the cpu was unlocked but it seems to be slightly unstable, I also want to configure the gpu, I feel that its full potential is wasted because it only reaches 68c with peaks of 70c stressing it in furmark

yes it did and it even fixed me some other bugs

I fixed it !!!!, I don't know what happened exactly but I fixed it, I opened my laptop and disconnected absolutely everything, remove ram and bios battery and turned it on and left it on for 5 minutes, the laptop did a strange process, it seemed that I was configuring something (It did not give...

no, I do not have a battery I cannot disconnect or it dies when investigating I discovered that the vaio flip series had defective batteries or they did not last long (bad design by the manufacturer) I suspect about the bios maybe it has a protection system

I tried it with a different voltage and it turned off, higher unstable and turns off immediately when stressed, if the low becomes very unstable and freezes, I have done some tests with the gpu without overclock but it still turns off but I have something new no I can stress cpu and gpu together...

ok i understand but i only have one question, why powercut interferes with my gpu?

ok I will not use powercutt but I just want to know what happened because I used powercutt in all of 2020 and it never gave problems until now, it seems to be a hardware crash by the way my laptop is a sony vaio svf15n17cxb the motherboard design is terrible. If you find a possible solution or...

not Gt 735m 1071 mhz core 1100mhz mem but only fails if I activate powercutt if I do not activate it is fully functional, I run the test in stock but still fails, only if I activate powercutt