the OS Has no capability to interact with the bios in the way you are telling you have a intermittent fault thats occurring/correcting every-time...
Ultravnc has a java based appetly that lets you connect anyware from a web-browser http://www.uvnc.com/
no need for 3d party payware
normally they do not even inspect the cards just make sure you don't tell them ;) the air temps are whats killing you there is nothing you can do...
you do not want Positive power numbers you WANT negative Negative means that the isp is not needing to push more power to get the signal to the...
when you amp the signal you add noise noise is bad a AMP is only a option if the following
A: its rated for The full frequency bands and does NOT...
A: his power level is fine so is his SNR I have worse then that here and I am less then 6 miles from the sub-switch
if your room is over 80-90f then those temps are normal
80c isn't gonna break it
how ever if your room is 65-70f then you might have a defective...
and make sure you replicate the folder
a single 6770 will be faster
the APU relies heavily on memory bandwidth for graphics the faster/tighter timings the better
Get the 560
better drivers better game support and 2GB of vram will make battlefield 3 happy
1: yes it does
2: see number 1
3: You can't call someone a idiot just because you lack the Knowledge
4: enjoy you're ban
Not sure if trolling
Just doesn't understand ...
we have only explained it 8 times
just because you don't understand it does not make it...
beware of cross load on Mulirail Psus
because no one wants to route 10AWG wire though there cases because 18 or 20AWG is more then enough :banghead:
because having more then one +12...
Op does not seem to understand how Ic's and voltage stepdown works
if you take 12v and step it down to say 1v you have a whole lotta amperage...
Kingston 8GB 240-Pin DDR3 SDRAM ECC Registered DDR... faster ram also registered should reduce the Memory load
Migth be overloading the Chipset/memory controler try adding some voltage to the QPI/PLL/Dram
after consulting the manual you need to be using the 8 PIN cpu power connector NOT THE 6 you can not run this board with just the 6pins the 6Pins...
its probly a little late for this but
Intel Xeon E5-2640 Sandy Bridge-EP 2.5GHz (3GHz Tu...
ASUS Z9PE-D8 WS Dual LGA 2011 Intel C602 SATA 6Gb/...
/me notes that dual socket boards are normally more headache then they are worth and that lga 1366 is dead anyway
all I can say is email evga directly they might know a trick or three not many people own the motherboard you have
you can try might be overloading the imc on cpu two
stupid question but do you have all the ram in the same back of dimms
when you use both sockets you need to spread the ram evenly between sockets...
Separate names with a comma.