0.5.4 start 4 instances simultaneusly = BSOD

[connector]

Hi!,
i have 2 radeon 5970s and i use to open 4 GPU-Z instances to "monitor" my GPU LOAD and VDDC Current. If i open the 4 instances "simultaneously" (without waiting for each to load), with LATEST CATALYST 11.6b (not with 11.6 or previous) i get a BSOD... if i wait all instances to open, there is no problem.

Do i have to wait all instances to open one by one?

Regards!

 

[2DividedbyZero]

did you not just answer your own question?

 

[W1zzard]

does the system bluescreen every time, or only sometimes?
when you open them one by one, slowly, there is no problem?

in that case, do that.

 

[connector]

does the system bluescreen every time, or only sometimes?
when you open them one by one, slowly, there is no problem?

in that case, do that.

Ok, i'll do that.

Previous versions (with previous Catalyst 11.6) doesn't cause problems when you open 4 instances "simultaneously" (only with Catalyst 11.6b called 11.7). I'll report it becuause it'll be the following "latest Catalyst"... BSODs only sometimes.

If i launch one by one, slowly, there is no problem...

ok, i'll do that, i'll open ond by one slowly...

In addition to this issue: i have stuttering when i have launched GPU-Z and a game simultaneously (with the check to update information ticked).

one suggestion: in Afterburner when I can set the "hardware poll intervall" to 3,000 ms and the stuttering does not occur... is it possible to add that control to GPU-Z?




Thanks,

 

[connector]

Ok, i'll do that.

Previous versions (with previous Catalyst 11.6) doesn't cause problems when you open 4 instances "simultaneously" (only with Catalyst 11.6b called 11.7). I'll report it becuause it'll be the following "latest Catalyst"... BSODs only sometimes.

If i launch one by one, slowly, there is no problem...

ok, i'll do that, i'll open ond by one slowly...

In addition to this issue: i have stuttering when i have launched GPU-Z and a game simultaneously (with the check to update information ticked).

one suggestion: in Afterburner when I can set the "hardware poll intervall" to 3,000 ms and the stuttering does not occur... is it possible to add that control to GPU-Z?




Thanks,

Any question?

 

[brandonwh64]

what is the BSOD stop code?

 

[connector]

what is the BSOD stop code?

It's like atimksdag.sys or something like this and the code was 116.

 

[Steevo]

too high of GPU voltage possibly?

 

[connector]

too high of GPU voltage possibly?

I'm at stock (speed and voltages)...