- Joined
- Jun 27, 2011
- Messages
- 6,687 (1.43/day)
| Processor | 7800x3d |
|---|---|
| Motherboard | Gigabyte B650 Auros Elite AX |
| Cooling | Custom Water |
| Memory | GSKILL 2x16gb 6000mhz Cas 30 with custom timings |
| Video Card(s) | MSI RX 6750 XT MECH 2X 12G OC |
| Storage | Adata SX8200 1tb with Windows, Samsung 990 Pro 2tb with games |
| Display(s) | HP Omen 27q QHD 165hz |
| Case | ThermalTake P3 |
| Power Supply | SuperFlower Leadex Titanium |
| Software | Windows 11 64 Bit |
| Benchmark Scores | CB23: 1811 / 19424 CB24: 1136 / 7687 |
My first time with water etc etc. I am not done yet. I am no here to show off but to ask for a little help finishing. Camera just died earlier today so had to use phone camera.
Right now I got the blocks installed. I am on the looping step. What you see in the pictures is just a mock up. I have not filled it with any water. I could really use some help figuring out where to mount the pump and route the tubing to and from the pump.
You can also see if have card board shunts holding the radiator in place. There is about 3mm on each side of the rad and it wobbled so I put those there. Anyone have any better ideas for holding the rad in place? I would of screwed it into the front via the fans but they don't line up perfectly.
Right now I got the blocks installed. I am on the looping step. What you see in the pictures is just a mock up. I have not filled it with any water. I could really use some help figuring out where to mount the pump and route the tubing to and from the pump.
You can also see if have card board shunts holding the radiator in place. There is about 3mm on each side of the rad and it wobbled so I put those there. Anyone have any better ideas for holding the rad in place? I would of screwed it into the front via the fans but they don't line up perfectly.
Last edited: